How do I sync with a Pocket Operator?

The KO II can sync with a Pocket Operator in either direction, either sending clock to it or receiving clock from it.

Sending clock from KO II to a Pocket Operator

1. 1.Plug a 3.5mm cable from the KO II's sync output into the input jack on the left side of the Pocket Operator.
2. 2.On the Pocket Operator, press the function button and the BPM button until the screen shows SY2.
3. 3.On the KO II, press shift and erase to open system settings.
4. 4.Navigate to sync, press enter, then navigate to OUT, press enter, then navigate to 8, press enter.
5. 5.Press play on the Pocket Operator, then press play on the KO II. Both will sync to the same BPM.

Receiving clock from a Pocket Operator

1. 1.You need a 3.5mm stereo (TRS) to 2x 3.5mm mono (TS) splitter cable. Connect the stereo end to the Pocket Operator's output, the right channel (ring) to the KO II's input jack, and the left channel (tip) to the KO II's sync input jack.
2. 2.On the Pocket Operator, set the sync mode to SY1.
3. 3.On the KO II, press shift and erase to open system settings.
4. 4.Navigate to sync, press enter, then navigate to IN, press enter, then navigate to 8, press enter.
5. 5.Press play on the Pocket Operator, then play on the KO II. As a bonus, with this setup you can also run the Pocket Operator's audio through the KO II's built-in effects.